It is a application that transfer and receive file by serial port It is a LCD picture capture application under Console platform
It is a camera picture capture application under Console platform It can be taken as net monitor when the application works with USB Camera. The application is running under Console platform, it controls the USB Camera by internet and displays the picture taken by camera on the LCD.
The chip of USB Camera is Vimicro 301p, the USB Camera is collecting dynamic picture and showing on the LCDĬMOS Camera, ADC Testing, Button Testing, PWM Testing, LCD Testing, Watchdog Testing, EEPROM Testing, LED Test, Serial Port test, Ping Testing, Recorder, Network setting, Backlight Testing, Language setting, Pen Pad Support via USB and Serial Interface to download application to flash debugĬoming with driver for 4.3" and 7" TFT LCD Support writing kernel image into nand flash and kernel parameter setting Also can be configured the board booting from Yaffs or NFS Start up system, supporting one Key to update Bootloader, Kernel, Yaffs, NK.bin and one Key to configure parameters of Linux. The reset circuit uses a MAX811 reset IC and there is an additional reset switch on the board: RST The Buzzer is connected to GPB0Ħ User Buttons. GPIO is on CON4, a 34 pin 2.0mm pitch connector. AIN0 is also connected to a 10k potentiometer (W1). There are four ADC channels on the board which are connected to the GPIO header (CON4). Supporting 4.3", 7" TFT LCDĭavicom DM9000EP MAC & PHY, 10/100BaseT, Activity LED'sįor communication control the USB Device has got an additional pin: USB_EN (GPC5). The LCD port integrated 4-wire resistor touch screen port. UART0 is also connected to a RS232 level converter and led out on COM0 (DB9 connector) The three serial ports are led out on CON1 (UART0), CON2 (UART1) and CON3 (UART2). 32bit,100MHz, default mounted 64MB SDRAM, it can be replaced into 128MBĭefault mounted 256MB, it can be replaced into 64MB to 1GB
0 kommentar(er)
